氨气敏电极法和纳氏试剂分光光度法对地表水中氨氮的比对测试

采用不同质量浓度的氨氮标准样品和实际样品,用氨气敏电极法和纳氏试剂分光光度法进行同步测试。结果表明,2种分析方法在水样氨氮质量浓度在0. 159～2. 81 mg/L范围内具有良好的可比性、精密性和准确性。氨气敏电极法的检出限为0. 03 mg/L,平行6次测定样品的相对标准偏差为0. 4%～4. 2%,加标回收率为85. 0%～110%;纳氏试剂分光光度法的检出限为0. 025 mg/L,平行6次测定样品的相对标准偏差为0. 5%～6. 4%,加标回收率为93. 0%～99. 8%。同时氨气敏电极法在样品预处理、试剂配制和分析时间上要优于纳氏试剂分光光度法。氨气敏电极法能够满足地表水自动监测在线比对实际工作的需求,该方法具有良好的适用性。     

半干法脱除球团烟气中的SO2及Hg0

采用钙基吸收剂及复合氧化剂半干法脱除模拟球团烟气中的SO_2及Hg~0,考察了多因素条件对吸收效果的影响。实验结果表明,在以NaClO和NaClO_2为复合氧化剂、 NaClO与NaClO_2体积比1∶0.5、复合氧化剂质量分数3%、反应温度110℃、钙基吸收剂质量3.0 g、模拟烟气进气流量1.2 L/min的条件下,SO_2和Hg~0的脱除率分别为98%和93%,证明钙基吸收剂与复合氧化剂对污染物球团烟气中的SO_2和Hg~0有良好的脱除作用。     

Effects of release pressure on the transportation characteristics in pipeline and the diffusion behaviors in enclosure space of typical gas extinguishing agent

Reducing the release pressure of fire extinguishing systems can decrease potential safety hazards in large transport airplanes. To explore whether reducing the release pressure can achieve the release effect required by the airworthiness standards or not, the transportation characteristics in the pipeline and diffusion behaviors in the enclosure space of a typical fire extinguishing agent (Halon 1301) were investigated under five release pressures in the present study. The effects of the release pressure on the degree of superheat, injection duration, jet structure, and concentration distribution of Halon 1301 were analyzed. The results show that both of the degree of superheat and the injection duration decrease with an increase in the release pressure. The supplement of bubble expansion in the fire extinguishing agent can slow down the pressure decrease in the vessel. Both of the maximum and mean values of the pipeline differential pressure increase with an increase in release pressure. The maximum value of the jet angle decreases linearly with the increase in release pressure, and the jet deflects upward owing to the effects of buoyancy. The maximum concentration value decreases with an increase in the distance from the nozzle. The maximum concentration values in the near field from the nozzle increase with an increase in the release pressure. Under five release pressures, the concentration and holding time (duration above 6% volume concentration) of Halon 1301 on the centerline of the jet meet the requirements of airworthiness provisions.     

The acceptance of personal protective equipment among Hong Kong construction workers: An integration of technology acceptance model and theory of planned behavior with risk perception and safety climate

Introduction: The phenomenon that construction workers do not use personal protective equipment (PPE) is a major reason for the high occurrence frequency of accidents in the construction industry. However, little efforts have been made to quantitatively examine the factors influencing construction workers’ acceptance of PPE. Method: In the current study, a PPE acceptance model for construction workers (PAMCW) was proposed to address the noted need. The PAMCW incorporates the technology acceptance model, theory of planned behavior, risk perception, and safety climate for explaining construction worker acceptance of PPE. 413 construction workers participated in this study to fill out a structured questionnaire. The PAMCW was analyzed using structural equation modeling. Results: Results provide evidence of the applicability of the technology acceptance model and theory of planned behavior to the PPE acceptance among construction workers. The positive influence of safety climate and risk perception-severity on attitude toward using PPE was significant. Safety climate positively influences perceived usefulness. Risk perception-worry and unsafe was found to positively affect intention to use PPE. Practical Applications: Practical suggestions for increasing construction workers’ use of PPE are also discussed.     

Inhibiting effects by Fe2O3 on combustion and explosion characteristics of ABS resin

The global increase in the use of, and reliance on, plastics has prompted the demand for acrylonitrile-butadiene-styrene (ABS) resin in various fields. With this increased requirement, numerous failures have occurred in the ABS process. Those incidents, resulting from electrostatic discharge, powder accumulation, heat accumulation, construction sparks, and plant fires, have caused dust fire and explosions.In this study, the ABS resin was gleaned from the site and tested for its explosion parameters, including minimum ignition temperature of dust cloud (MIT_C), minimum ignition energy (MIE), and minimum explosion concentration (MEC). To improve loss prevention in the manufacturing process, ferric oxide (Fe₂O₃) as an inert additive was added in the ABS powder. According to the MIE test, Fe₂O₃ has an apparent inhibiting effect on dust explosion for the ABS dust. With the proportion of Fe₂O₃ increased from 25 to 50 mass% in ABS, the MIE increased from 67 to 540 mJ. The explosion tests via 20-L apparatus indicated that Fe₂O₃ mixed with ABS could not increase the MEC significantly. However, the explosion pressure dropped by increasing in the ratio of Fe₂O₃ in ABS. This inerting strategy of ABS was deemed to substantially lessen the probability and severity of fire and explosion.     

Assessment of the effect of technical and management characteristics on the frequency of release from piping: An application to a gas storage facility

The assessment of the frequencies of release from piping due to losses of containment is an essential step in the preparing Safety Reports, drawn up as required by the so-called “Seveso” Directive. These are usually calculated starting from the frequencies of random rupture included in international databases and are not plant-specific, furthermore, the quantification of the effect of the safety management system of the facility is not easy. A simple and flexible approach quantifying technical and management characteristics of the plant has been proposed by Milazzo and co-workers in 2010; it is based on the modification of the frequency taken from literature, through the use of the percentages of failure causes actually possible in that plant, and the judgment about their management. The data about the failure causes are taken from the literature and modified by using corrective factors to adapt them to the industrial context. To make possible the application of the method to a large number of major-hazard industry types, some aspects of the approach needed to be improved; these have been identified during a development project coordinated by RINA Consulting, on behalf of Saipem, with the collaboration of the University of Messina. The improvement of the approach focused on two main points, the development of a method to calculate the corrective factors for the failure causes associated with corrosion and erosion phenomena and the strengthening of the methodology for the formulation of the judgment about the safety management. This paper illustrates the fully improved method, as well as an application to a typical gas storage plant.     

高效复合菌在木薯酒精废液处理中的应用研究

对酒精废液生物处理反应器内颗粒污泥中的微生物进行分离纯化.分离出的8株高效优势菌,初步鉴定结果:1号为皮杆菌属;2号为棒杆菌属;3号、4号为微小杆菌属;5号为乳杆菌属;6号为纤维单胞菌属;7号为丙酸杆菌属;8号为红长命菌属.对8种纯化后的菌株进行混合培养,确定了复合菌群生长最佳培养温度为37℃,最适pH值为6.8.在处理过程中投加适量葡萄糖、硝酸铵和微量元素能够提高复合菌群的处理效果.最佳添加量为:葡萄糖0.5g/L,硝酸铵1g/L,Fe2 5mg/L和Ca2 25mg/L.在日处理量100 m3的UASB生物反应器中投加该复合菌群后,木薯酒精废液的COD去除率明显提高,达到90%以上.处理系统运行稳定.     

模糊综合评价法在道路运输企业安全评价中的应用

我国道路运输企业交通安全形势比较严峻,推行道路运输企业安全综合评价是降低道路运输企业交通事故的有效途径之一.本文运用Delphi法和AHP法建立了道路运输企业安全层次分析模型,构建了安全综合评价指标体系.选用基于"差动"原理的赋权法--G1法计算各指标的权重,应用模糊综合评价法对其进行安全综合评价.采用平均加权法对评价因素的各项指标进行量化处理,从而得到道路运输企业安全的综合评价结果.最后,对陕西省一家道路运输企业进行了实际验证,比较真实地反映了此企业的安全状况.     

基于模糊聚类关联分析法的煤与瓦斯突出程度分析

运用模糊聚类分析方法对煤与瓦斯突出的样本集合进行分类,建立了不同突出程度的模糊模式.用关联分析确定待分析样本与模式的关联程度,以此预测预报样本的煤与瓦斯突出危险程度.实例分析表明,与模糊聚类分类后、将模式与待预报样本组成新样本集合进行聚类分析并以此分类结果进行预报的方法相比,这种预报方法不仅可靠程度高,而且能定量描述待报样本与模式的亲和程度.     

南黄海东部海域浮游生态系统要素季节变化的模拟研究

利用海洋生态系统动力学垂直一维物理-生物耦合模式模拟研究了南黄海东部海域浮游生态系统要素垂直分布的季节变化.物理亚模型为一维POM模式(Princeton Ocean Model),基于文献结果对垂直混合系数Kh和Km进行了调整;生态亚模型为ERSEM模式(European Regional Sea Ecosystem Model),主要考虑浮游植物、浮游动物、细菌、底栖碎屑和营养盐(氮、磷、硅)等状态变量.模拟结果表明,浮游植物出现一年双峰的态势和夏季次表层叶绿素最大值的现象,春、秋季水华期间,表层叶绿素峰值分别为3.25 mg/m3和0.71 mg/m3.浮游动物和细菌在春季水华后表层出现峰值,分别为143.6 mg C/m3和23.55 mg C/m3.硝酸盐、磷酸盐和硅酸盐的垂直分布均在5-11月呈现表层浓度低、底层浓度高的分布.通过计算碳通量可以看出,在春、夏季,浮游植物对无机碳的摄取量分别为58.944 g C·m-2·quarter-1和68.276 g C·m-2·quarter-1,高于细菌对非生命有机碳的摄取.在冬季,细菌对非生命有机碳的摄取超过浮游植物对无机碳的摄取量.浮游动物在冬季主要摄食细菌,占71%;春、夏季主要摄食浮游植物,可达67.5%.浮游植物对碳的释放主要是以DOC的形式,约占90%.